Mani Raj Paul - TCP - Error Conrol, Flow Control & Multiplexing

Error Control &and Flow Control

TCP uses port numbers to know what application process it needs to handover the data segment. Along with that, it uses sequence numbers to synchronize itself with the remote host. All data segments are sent and received with sequence numbers. The Sender knows which last data segment was received by the Receiver when it gets ACK. The Receiver knows about the last segment sent by the Sender by referring to the sequence number of recently received packet.
If the sequence number of a segment recently received does not match with the sequence number the receiver was expecting, then it is discarded and NACK is sent back. If two segments arrive with the same sequence number, the TCP timestamp value is compared to make a decision.

Multiplexing

The technique to combine two or more data streams in one session is called Multiplexing. When a TCP client initializes a connection with Server, it always refers to a well-defined port number which indicates the application process. The client itself uses a randomly generated port number from private port number pools.
Using TCP Multiplexing, a client can communicate with a number of different application process in a single session. For example, a client requests a web page which in turn contains different types of data (HTTP, SMTP, FTP etc.) the TCP session timeout is increased and the session is kept open for longer time so that the three-way handshake overhead can be avoided.
This enables the client system to receive multiple connection over single virtual connection. These virtual connections are not good for Servers if the timeout is too long.

Comments

Post a Comment

Popular posts from this blog

Mani Raj Paul - DPCM

Image
For the samples that are highly correlated, when encoded by PCM technique, leave redundant information behind. To process this redundant information and to have a better output, it is a wise decision to take a predicted sampled value, assumed from its previous output and summarize them with the quantized values. Such a process is called as  Differential PCM (DPCM) technique. DPCM Transmitter The DPCM Transmitter consists of Quantizer and Predictor with two summer circuits. Following is the block diagram of DPCM transmitter. DPCM Receiver The block diagram of DPCM Receiver consists of a decoder, a predictor, and a summer circuit. Following is the diagram of DPCM Receiver. The notation of the signals is the same as the previous ones. In the absence of noise, the encoded receiver input will be the same as the encoded transmitter output. As mentioned before, the predictor assumes a value, based on the previous outputs. The input given to the decoder is...
Read more

Mani Raj Paul - Quantization

Image
Quantization The digitization of analog signals in which it involves the rounding off of the values which are approximately equal to the analog values.  sampling chooses a few points on the analog signal and then these points are joined to round off the value to a near stabilized value. Such a process is called as  Quantization . Types of Quantization There are two types of Quantization - Uniform Quantization and Non-uniform Quantization. The type of quantization in which the quantization levels are uniformly spaced is termed as a  Uniform Quantization . The type of quantization in which the quantization levels are unequal and mostly the relation between them is logarithmic, is termed as a  Non-uniform Quantization . There are two types of uniform quantization. They are Mid-Rise type and Mid-Tread type. The following figures represent the two types of uniform quantization. In this the origin lies in the middle of a raising part of the stair-case lik...
Read more